Services
As well as straight forward painting and decorating, we offer many specialist services that may require extra attention if you require.
These include:
Cracks in Plaster - The development of small cracks on inside plaster walls and ceilings is not unusual and is normally the result of drying out (in the case of new houses) or movement of the building.
Large cracks that appear to be getting wider should be investigated by a buildings surveyor.
Flaking / Blistering of Paint on Wood - This is most commonly caused by moisture beneath the paint film. Knots in the timber can also lead to blistering. Flaking can occur if paint has been applied over denatured wood, dirt, grease, etc. Movement of the wood, particularly on joints can cause it to crack. This can allow moisture to penetrate the wood which in time can lead to flaking. Areas of flaking or blistering paint should be removed by scraping back to a firm edge using a paint scraper. Sand down to smooth edges. If the problem is extensive the surface should be stripped back to bare wood. All knots streaks should be treated Knotting Solution and then bare wood should be primed. Make good all open joints and surface with suitable wood filler.
Condensation Control - Most condensation in buildings is caused by warm moist air coming in contact with cooler surfaces. In houses condensation is most likely to occur in kitchens and bathrooms.Some forms of heating generate large volumes of moisture vapour, paraffin stoves being the most notable. Condensation is best prevented or controlled by providing good ventilation. Heating combined with good ventilation will reduce the problem. Special anti-condensation paints will provide short term relief, but painting alone will not cure the problem. Conditions within the building must be improved.
Dampness in Walls - Where damp is a problem it may be due to a defective or missing DPC, broken or defective rainwater pipes and gutters, defective pointing in brickwork, unsuitable cladding, solid wall construction or other general building defects. The source of the dampness should be found and cured. The surface must be allowed to completely dry before painting. A shellac based sealer can then be applied prior to overpainting in the finish required.